Panasonic KX-TDA50

4.15 Private Network [9]
Feature Guide 625
4.15.3 Network Operator (VoIP) [9-3]
Settings related to the network operator can be programmed. The settings on this screen should be
programmed at the PBX that is to be monitored (Network PBX ID 2–8).
Network Operator Extension No.
Specifies the number of an extension at the monitor PBX (the PBX whose Network PBX ID is set to 1 in
4.15.1 TIE Table [9]). Any extension at the monitor PBX can be specified here.
Default
Not stored.
Value Range
Max. 16 digits (consisting of 0–9, *, and #)
Programming References
Network PBX ID—4.15.2 Network BLF Data Transfer [9-2]
Feature Guide References
1.25.2.3 Network Direct Station Selection (NDSS) (KX-TDA5920 required)
IP-GW Card Slot No. to notify BLF data to Network Operator
Specifies the slot number of the card used to send extension status data. This setting is only required when
using VoIP to transmit data.
Default
Undefined
Value Range
Undefined, 5–7
Programming References
4.7.1 Slot [1-1]
Feature Guide References
1.25.2.3 Network Direct Station Selection (NDSS) (KX-TDA5920 required)
4.15.4 NDSS Key Table [9-4]
Extensions at another PBX that will be monitored can be registered. A maximum of 32 extensions can be
registered. To create an NDSS button to monitor an extension, the extension must be registered here first.
The parameters on this screen can only be set when the Network PBX ID is set to 1 in the 4.15.1 TIE Table
[9] screen.