2.3 System Data Control
Feature Guide 235
2.3.4 Automatic Time Adjustment
Description
The PBX clock can be adjusted automatically in the following two ways:
1. Daylight Saving Time Setting
The start and end dates of Daylight Saving Time can be programmed. The PBX clock will automatically
adjust itself one hour forward or backward at 2:00 A.M. on the programmed date, if enabled through
system programming. At 2:00 A.M. on the start date, the clock will change to 3:00 A.M., and at 2:00
A.M. on the end date, the clock will change to 1:00 A.M.
Note
If a Timed Reminder (Wake-up call) is set:
– On the Daylight Saving Time start date, a reminder set for between 2:00 A.M. and 3:00 A.M. will
not ring.
– On the Daylight Saving Time end date, a reminder set for between 1:00 A.M. and 2:00 A.M. will
ring twice.
2. Time Information from Telephone Company
Time information can be received when an incoming call through an analog line with Caller ID which
includes time information is received.
The PBX clock will be adjusted everyday with the first call after 3:05 AM, if enabled through system
programming.
Note
If a Timed Reminder (Wake-up call) is set, the setting will not ring or will ring twice depending on the
adjustment.
Flexible
Numbering Type
1. Pattern 1
(with )
2. Pattern 2
(without )
Select whether or not the prefix " " must be entered before dialing
feature numbers.
[Example] Call Pickup feature number
Pattern 1 (with ): 41
Pattern 2 (without ): 41
Note that certain feature numbers (Line Access numbers, Operator
Call, etc.) never need this prefix.
For a list of the default flexible numbers, refer to the [Flexible
Numbering Table (available while a dial tone is heard)] (→ 2.3.5
Flexible Numbering/Fixed Numbering).
Operator/Local
Access
1. 0/9
2. 9/0
Select the feature numbers for Operator Call and Idle Line Access.
These will be either 0 and 9, respectively, or 9 and 0, respectively.
Remote
Maintenance
Number
Remote
Maintenance Dial
Number
Enter the complete telephone number of the PBX (including the
country code). When necessary, this number will be used to access
the PBX from a remote location for maintenance purposes.
Item Parameter Description
To Next Page
Loading...
