Panasonic KX-TDA50

1.16 Caller ID Features
Feature Guide 127
1.16 Caller ID Features
1.16.1 Caller ID
Description
The PBX can receive Caller ID information (a caller's name and telephone number) from calls received on
analog CO lines. This information can be shown on a proprietary telephone (PT) display when receiving a
call and can be used to direct calls from specific callers to specific destinations automatically. Additionally,
Caller ID information is logged in the Incoming Call Log of the extension which received the call, allowing
the caller to view a record of incoming calls or make a call to a person in the call log later.
The PBX can be programmed to modify a caller's telephone number when it is received and, for example,
add a CO Line Access number or add/delete certain digits of incoming telephone numbers automatically.
This allows an extension user to be able to make a call later to a telephone number logged in his or her call
log without worrying about CO Line Access numbers, area codes, etc.
Notes
• The term "Caller ID" used in this Feature Guide refers to features that can receive caller
information sent from the telephone company and received on analog CO lines. Your network
provider may use a different name for this type of service.
• To receive Caller ID information, you must subscribe to the telephone company's Caller ID service
and enable Caller ID for the appropriate CO line through system programming.
Caller ID to SLT Port:
Caller ID information can also be shown on a single line telephone (SLT) display. This feature is available
only for SLTs compatible with FSK-type Caller ID.
Note
This feature is compatible with ETSI-type FSK and Bellcore-type FSK.
1. Caller ID-Related Features
Features Description Details in
Calling Line Identification
(CLI) Distribution
Caller ID information received by the PBX is used to
direct calls from specific callers to specific
destinations. The caller's telephone number and a
destination must be assigned in the System Speed
Dialing Table.
• 1.1.1.3 Calling
Line Identification
(CLI) Distribution
Incoming Call Log Caller information is automatically recorded in the
call log of the extension which received the call. This
information can be used to view a record of incoming
calls or make calls to any number in the call log.
• 1.16.2 Incoming
Call Log