4.11 Optional Device [5]
592 Feature Guide
Programming References
4.7.1 Slot [1-1]
Feature Guide References
1.15.6 Direct Inward System Access (DISA)
Cyclic Tone Option—Tone Off Maximum Time
Specifies the maximum time the PBX waits for a cyclic tone to be sent from the telephone company before
recognizing it as a tone-off. When no tone is detected within the time set here, the PBX recognizes it as a
tone-off.
To change Cyclic Tone Option, follow the steps below:
1. Change Cyclic Tone Option.
2. Set the status of the MSG2 card to "OUS", then "INS".
Default
600 ms
Value Range
100 + 10 x n (n=1–390) ms
Programming References
4.7.1 Slot [1-1]
Feature Guide References
1.15.6 Direct Inward System Access (DISA)
Repeating Times of On / Off for Detection
Specifies the number of times the tone pattern (a set of tone-on and tone-off) must be received to establish
reception of the cyclic tone. This determines the end of call.
Default
3
Value Range
3–16
Programming References
None
Feature Guide References
1.15.6 Direct Inward System Access (DISA)
4.11.4 DISA—Message Setting [5-3-2]
Outgoing messages (OGM) for DISA calls can be specified. A maximum of 32 OGMs can be programmed.
To Next Page
Loading...
