Panasonic KX-TDA50

1.5 Making Call Features
Feature Guide 61
Conditions
• An account code can be stored in Memory Dialing (One-touch Dialing, for example).
• Account Button
A flexible button can be customized as the Account button. The Account button is used in place of the
feature number for entering an account code. This button is useful because it can be used at any time,
while feature number entry is allowed only when hearing a dial tone before seizing a CO line.
• Account code entry after receiving a disconnection signal from a CO line must be done while hearing
a reorder tone. Otherwise the SMDR call record is logged and entry becomes impossible afterwards.
• If an account code is entered more than once, the code entered last is logged in the SMDR.
• Even in Forced mode, emergency numbers can be dialed without an account code. (→ 1.5.4.2
Emergency Call)
• Proprietary telephone (PT) users can also enter an account code for incoming CO line calls during a
conversation.
• Verified Code Entry
To identify who made a CO line call for accounting and billing purposes, a verified code can be used.
This code can be used at any extension. (→ 1.8.5 Verified Code Entry)
Feature Guide References
1.18.2 Flexible Buttons
1.21.1 Station Message Detail Recording (SMDR)
User Manual References
1.2.1 Basic Calling
1.5.4.4 Dial Type Selection
Description
The dialing mode (rotary or tone) can be selected for each analog CO line through system programming (→
LCOT Dialing Mode [410]) regardless of originating extension (under contract with the telephone company).
Conditions
• Pulse to Tone Conversion
It is possible for an extension user to temporarily switch from Pulse mode to DTMF mode in order to
access special services such as computer-accessed long distance calling or voice mail services. To
switch to DTMF mode, wait for a preprogrammed time period (Default: 5 seconds) after the CO line is
connected, or press . This feature works only on CO lines set to Pulse mode. DTMF mode cannot be
changed to Pulse mode.
Mode Description
DTMF (Dual Tone Multi-
Frequency)
Numbers dialed by an extension user are transmitted to the CO line using
analog tones.
Pulse Dial (Rotary) Numbers dialed by an extension user are transmitted to the CO line using
analog pulses.