4.3 Connect
Feature Guide 291
4.3.3 Connect—Modem
Connects to the PBX in Interactive mode through the modem.
To access the PBX remotely using this feature, an RMT card must be installed and the analog remote
maintenance floating extension number assigned. For more details, see "4.17.3 Miscellaneous [11-3]".
The settings are as follows:
The functions of the buttons on this screen are as follows:
Setting Values Description
Profile Name – Enter a name used to identify this set of
values.
Port COM1–COMx Specify the number of the COM port
assigned to the PC's modem interface.
Only available COM ports will be
displayed.
NL Code CR, CR+LF Specify the code to be sent to signify the
end of a line. Choose CR+LF.
Baud Rate 1200bps, 2400bps,
4800bps, 9600bps,
19200bps, 38400bps
Specify the speed of data transmission.
Flow Control None, Hardware Specify whether the rate of data transfer
is managed by hardware or not. Choose
Hardware.
Command – Enter the modem initialize command.
For more details, refer to your modem's
instruction manual.
Dial Number 1-9, 0, *, and # Enter the telephone number to be dialed
to access the PBX.
Dial Type Auto(Tone),
Auto(Pulse), Manual
Specify the outgoing dialing method.
If Manual is chosen, dialing must be
done with a connected telephone.
Password – Enter the password corresponding to the
Programmer Code used to log on to the
Maintenance Console.
Save Password Checked, not checked Select whether to save the password
when the profile is saved.
Comment – Enter a comment to help to identify this
profile.
Button Function
Save Saves the current profile information.
Delete Deletes the current profile information.
To Next Page
Loading...
