3.3 PT Programming
Feature Guide 255
3.3 PT Programming
3.3.1 Programming Instructions
Requirements
PBX settings can be customized through system programming by using a proprietary telephone (PT) with
a multiline display, such as the KX-T7636. To access system programming, the Class of Service (COS)
assigned to the PT's extension must be programmed to allow system programming, or the PT must be
connected to the lowest numbered port on the card installed in the lowest numbered slot.
Only one system programming session can be performed at a time, i.e., only one extension user can access
system programming at a time. This includes PC programming.
For a list of characters that can be entered during system programming, see Section 3.1.3 Entering
Characters.
To Next Page
Loading...
