4.15 Private Network [9]
624 Feature Guide
Programming References
None
Feature Guide References
1.25.1.2 PBX Code Method (Access with PBX Code)
1.25.1.3 Extension Number Method (Access without PBX Code)
Trunk Group—Priority 1–Priority 8
Specifies the CO line group to be used for TIE line calls for each priority.
Default
None
Value Range
None, 1–64
Programming References
None
Feature Guide References
1.25.1.2 PBX Code Method (Access with PBX Code)
1.25.1.3 Extension Number Method (Access without PBX Code)
4.15.2 Network BLF Data Transfer [9-2]
Settings related to the transmission of extension BLF (Busy Line Field) data over a network of PBXs can be
programmed. This data is used to show the status of a monitored extension attached to another PBX on a
Network DSS button.
Network BLF(DSS) Data Broadcasting Interval Timer
Specifies the frequency of BLF data transmission. The PBX will send data over the network periodically
according to the interval specified here.
Default
3000 ms
Value Range
100 × n (n=0–30) ms
Programming References
None
Feature Guide References
1.25.2.3 Network Direct Station Selection (NDSS) (KX-TDA5920 required)
To Next Page
Loading...
