4.8 System [2]
370 Feature Guide
Waiting Timer to Receive Analog Caller ID
Specifies the length of time the PBX waits before receiving Caller ID from an analog CO line. If the Caller
ID is received through the analog CO line card on which no Caller ID card is mounted or through the port to
which Caller ID Detection is disabled, this timer is not applicable.
Default
5 s
Value Range
0–15 s
Programming References
4.12.1 Speed Dialing & Caller ID—Main Table [6-1-1]
4.12.2 Speed Dialing & Caller ID—Caller ID Modification [6-1-2]
Feature Guide References
1.16.1 Caller ID
Visual Caller ID Display Timer
Specifies the length of time the Caller ID number, with the Call Waiting tone offered by an analog line from
the telephone company, is shown on the display. The Caller ID number flashes on the display twice for five
seconds at 15-second intervals.
Default
30 s
Value Range
0–250 s
Programming References
None
Feature Guide References
1.1.3.3 Call Waiting
External Sensor Ringing Continuous Timer
Specifies the length of time that the PBX waits for the called party to answer before canceling a sensor call.
Default
30 s
Value Range
10 × n (n=1–15) s
Programming References
None
To Next Page
Loading...
