Panasonic KX-UTG200

LLDP-MED Interval Timer (5-3600s)
Description Specifies the interval, in seconds, between sending each LLDP frame.
Value Range 5–3600
Default Value 30
Configuration File Reference LLDP_INTERVAL (Page 275)
4.3.4.3 CDP Settings
Enable CDP
Description Selects whether to enable or disable sending and receiving CDP
frames.
Note
• You should specify "Yes" for only one of "VLAN", "LLDP" or
"CDP".
• If "Yes" is specified for two or more of the parameters above,
the settings are prioritized as follows: "VLAN" > "LLDP" >
"CDP". Therefore, if "Yes" is specified for both "VLAN" and
"CDP", the VLAN-related settings are used.
Value Range
• Yes
• No
Default Value Yes
Configuration File Reference CDP_ENABLE (Page 276)
CDP Interval Timer
Description Specifies the time between CDP messages.
Value Range 5–3600
Default Value 30
Configuration File Reference CDP_INTERVAL (Page 276)
104 Administrator Guide Document Version 2015-01
4.3.4 Ethernet Port Settings