Panasonic KX-UTG200

4.5.3.4 Jitter Buffer
Maximum Delay
Description Specifies the maximum delay, in 10-millisecond units, of the jitter buffer.
Value Range
3–50 (´ 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be greater than [Initial Delay]
– This value must be greater than [Minimum Delay]
– [Initial Delay] must be greater than or equal to [Minimum
Delay]
Default Value
20 (´ 10 ms)
Configuration File Reference MAX_DELAY (Page 322)
Minimum Delay
Description Specifies the minimum delay, in 10-millisecond units, of the jitter buffer.
Value Range
1 or 2 (´ 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be less than or equal to [Initial Delay]
– This value must be less than [Maximum Delay]
– [Maximum Delay] must be greater than [Initial Delay]
Default Value
2 (´ 10 ms)
Configuration File Reference MIN_DELAY (Page 323)
Initial Delay
Description Specifies the initial delay, in 10-millisecond units, of the jitter buffer.
Value Range
1–7 (´ 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be greater than or equal to [Minimum
Delay]
– This value must be less than [Maximum Delay]
Default Value
2 (´ 10 ms)
Configuration File Reference NOM_DELAY (Page 323)
Document Version 2015-01 Administrator Guide 135
4.5.3 VoIP Settings [Line 1]–[Line n]