Panasonic KX-UTG200

4.3.4.1 Link Speed/Duplex Mode
LAN Port
Description Selects the connection mode (link speed and duplex mode) of the LAN
port.
Value Range
• Auto Negotiation
• 1000 Mbps/Full Duplex
• 100 Mbps/Full Duplex
• 100 Mbps/Half Duplex
• 10 Mbps/Full Duplex
• 10 Mbps/Half Duplex
Default Value Auto Negotiation
PC Port
Description Selects the connection mode (link speed and duplex mode) of the PC
port.
Value Range
• Auto Negotiation
• 1000 Mbps/Full Duplex
• 100 Mbps/Full Duplex
• 100 Mbps/Half Duplex
• 10 Mbps/Full Duplex
• 10 Mbps/Half Duplex
Default Value Auto Negotiation
4.3.4.2 LLDP Settings
Enable LLDP
Description Selects whether to enable or disable sending and receiving LLDP
frames.
Note
• You should specify "Yes" for only one of "VLAN", "LLDP" or
"CDP".
• If "Yes" is specified for two or more of the parameters above,
the settings are prioritized as follows: "VLAN" > "LLDP" >
"CDP". Therefore, if "Yes" is specified for both "VLAN" and
"LLDP", the VLAN-related settings are used.
Value Range
• Yes
• No
Default Value Yes
Configuration File Reference LLDP_ENABLE (Page 275)
Document Version 2015-01 Administrator Guide 103
4.3.4 Ethernet Port Settings