IPv6 DNS1
Description Specifies the IPv6 address of the primary DNS server.
Value Range Max. 46 characters
Default Value Not stored.
Configuration File Reference IPV6_STATIC_DNS1_SERVER (Page 273)
IPv6 DNS2
Description Specifies the IPv6 address of the secondary DNS server.
Value Range Max. 46 characters
Default Value Not stored.
Configuration File Reference IPV6_STATIC_DNS2_SERVER (Page 273)
4.3.4 Ethernet Port Settings
This screen allows you to change the connection mode of the Ethernet ports and the VLAN settings.
Note
• When you change the settings on this screen and click [Save], after the message "Save Complete!"
has been displayed, the unit will restart automatically with the new settings applied. If a unit is on a call
when "Save Complete!" has been displayed, the unit will restart after the unit returns to idle.
• Incorrect settings may cause a network failure. In such a case, you cannot access the Web user
interface anymore. To access it again, you need to correct the speed/duplex settings or perform IP
Reset through phone user interface programming. For details, refer to the Operating Instructions on
the Panasonic Web site (® see Introduction).
102 Administrator Guide Document Version 2015-01
4.3.4 Ethernet Port Settings
To Next Page
Loading...
