Panasonic KX-UTG200

Description Specifies the URL of the product configuration file, which is used when
all units with the same model number need the same settings.
Note
• When you change this setting, set "PROVISION_ENABLE" to
"Y" at the same time.
Value Range Max. 1024 characters
Note
• The format must be RFC 1738 compliant, as follows:
"<scheme>://<user>:<password>@<host>:<port>/<url-path>"
– "<user>" must be less than 127 characters.
– "<password>" must be less than 127 characters.
– "<user>:<password>@" may be empty.
– ":<port>" can be omitted if you do not need to specify the
port number.
• If "{mac}" is included in this URL, it will be replaced with the
unit’s MAC address in lower-case.
• If "{MAC}" is included in this URL, it will be replaced with the
unit’s MAC address in upper-case.
• If "{MODEL}" is included in this URL, it will be replaced with the
unit’s model name.
• If "{fwver}" is included in this URL, it will be replaced with the
unit’s firmware version.
• If this URL ends with "/" (slash), "{MODEL}.cfg" is automatically
added at the end of the URL.
For example, CFG_PRODUCT_FILE_PATH="http://host/
dir/" becomes CFG_PRODUCT_FILE_PATH="http://
host/dir/{MODEL}.cfg".
Default Value Empty string
Note
• The URL specified by your phone system dealer may be preset
in the unit.
CFG_MASTER_FILE_PATH
Value Format String
Description Specifies the URL of the master configuration file, which is used when
all units need the same settings.
Note
• When you change this setting, set "PROVISION_ENABLE" to
"Y" at the same time.
Document Version 2015-01 Administrator Guide 243
5.3.2 Configuration File Settings