Panasonic KX-UTG200

Value Range Max. 1024 characters
Note
• The format must be RFC 1738 compliant, as follows:
"<scheme>://<user>:<password>@<host>:<port>/<url-path>".
– "<user>" must be less than 127 characters.
– "<password>" must be less than 127 characters.
– "<user>:<password>@" may be empty.
– ":<port>" can be omitted if you do not need to specify the
port number.
• If "{mac}" is included in this URL, it will be replaced with the
unit’s MAC address in lower-case.
• If "{MAC}" is included in this URL, it will be replaced with the
unit’s MAC address in upper-case.
• If "{MODEL}" is included in this URL, it will be replaced with the
unit’s model name.
• If "{fwver}" is included in this URL, it will be replaced with
"FIRM_VERSION" depending on the system. Note that this rule
differs from other parameters such as "SIP_USER_AGENT".
Default Value Empty string
Web User Interface Reference Firmware File URL (Page 184)
FIRM_UPGRADE_AUTO
Value Format Boolean
Description Specifies whether to display a confirmation message asking the user
to perform a firmware update (manual) or perform the firmware update
without asking the user (automatic) when the unit detects a change in
the firmware version.
Note
• This setting is available only when
"FIRM_UPGRADE_ENABLE" is set to "Y".
• Changing this setting may require restarting the unit.
Value Range
• Y/Yes (Enable automatic firmware update)
• N/No (Disable automatic firmware update)
Default Value
Y
FIRM_UPGRADE_SUPPORT_IMAGE_MODE
Value Format Integer
Description This flag determines whether either normal or single image files, or both
image files are supported by firmware upgrade.
254 Administrator Guide Document Version 2015-01
5.4.5 Firmware Update Settings