Panasonic KX-UTG200

Element Available Value Description
Macro Timer T, t Example: "1x.T"
If the dialed phone number begins with "1", the call is made
after a lapse of "T" seconds.
• The value of "T" or "t" can be configured through the Web
user interface (® see [Timer for Dial Plan] in
4.6.1.1 Call Control).
Reject ! Example: "123xxx!"
If the dialed phone number is "123" followed by 3 digits, the
call is not made.
Second dial
tone
, Example: "9,xxxx"
Go off hook. If there is internal dial tone, dial "9" to make a
call immediately.
Go off hook. if there is the second dial tone (an outside dial
tone), dial any 4 numbers to make a call immediately.
Alternation | Example: "1xxxx|2xxx"
If the dialed phone number is "1" followed by 4 digits, or "2"
followed by 3 digits, the call is made immediately.
You can use this element to specify multiple numbers.
Negate [^ ] Example: "12[^345]"
If the dialed phone number is "12" followed by either one of
"3", "4", or "5", the call is not made.
If the dialed phone number is "12" followed by one character
excluding "3", "4", and "5", the call is made immediately.
Optional ? Example: "1?234"
If the dialed phone number is "1234", the call is made
immediately.
If the dialed phone number is "234", the call is made
immediately.
Repeat { } Example: "123{4}"
If the dialed phone number is "12" followed by "3" for 4 times
("3333"), the call to "123333" is made immediately.
Note
• You can enter up to 1024 characters in [Dial Plan].
• You can assign up to 128 dial plans separated by "|" in [Dial Plan].
• You can assign up to 1024 digits per dial plan in [Dial Plan].
• After the user completes dialing, the unit immediately sends all the dialed digits if [Call Even If Dial
Plan Does Not Match] is set to [Yes] in the Web user interface or if
"DIAL_PLAN_NOT_MATCH_ENABLE" is set to "N" in a configuration file. The unit recognizes the end
of dialing as follows:
– The inter-digit timer expires (® see [Inter-digit Timeout] in 4.6.1.1 Call Control in the Web user
interface or "INTDIGIT_TIM" in 5.6.1 Call Control Settings in the configuration file).
– The user presses [ENTER] or the # key.
– The call is initiated after going off-hook (pre-dial).
Document Version 2015-01 Administrator Guide 373
6.2.1 Dial Plan Settings