Need help?Do you have a question about the Philips LPC2129 and is the answer not in the manual?
Configuration and operation of the Phase Locked Loop for clock frequency multiplication.
Explanation of reset sources, behavior, and interaction with the wakeup timer.
Configuration of pin multiplexing for connecting peripherals to microcontroller pins.
Details on registers for CAN controllers, including mode, command, and status.
Details the boot loader's role in initial operation and flash memory programming.
Describes the In-System Programming commands for flash memory interaction.
Details the registers for configuring the ETM macrocell.
Key features of RealMonitor for real-time debug without halting the system.
General| Architecture | ARM7TDMI-S |
|---|---|
| Core | ARM7 |
| Clock Speed | 60 MHz |
| Flash Memory | 256 KB |
| RAM/SRAM | 16 KB |
| GPIO Pins | 46 |
| ADC Channels | 8 |
| ADC Resolution | 10-bit |
| DAC | No |
| UART | 2 |
| I2C | 1 |
| SPI | 1 |
| PWM | Yes |
| RTC | Yes |
| Operating Voltage | 3.0V to 3.6V |
| Package | LQFP64 |
| Timers | 2 x 16-bit, 2 x 32-bit |
To Next Page