RealMonitor 304 May 03, 2004
Philips Semiconductors Preliminary User Manual
LPC2119/2129/2194/2292/2294ARM-based Microcontroller
REALMONITOR BUILD OPTIONS
RealMonitor was built with the following options:
RM_OPT_DATALOGGING=FALSE
This option enables or disables support for any target-to-host packets sent on a non RealMonitor (third-party) channel.
RM_OPT_STOPSTART=TRUE
This option enables or disables support for all stop and start debugging features.
RM_OPT_SOFTBREAKPOINT=TRUE
This option enables or disables support for software breakpoints.
RM_OPT_HARDBREAKPOINT=TRUE
Enabled for cores with EmbeddedICE-RT. This device uses ARM-7TDMI-S Rev 4 with EmbeddedICE-RT.
RM_OPT_HARDWATCHPOINT=TRUE
Enabled for cores with EmbeddedICE-RT. This device uses ARM-7TDMI-S Rev 4 with EmbeddedICE-RT.
RM_OPT_SEMIHOSTING=FALSE
This option enables or disables support for SWI semi-hosting. Semi-hosting provides code running on an ARM target use of
facilities on a host computer that is running an ARM debugger. Examples of such facilities include the keyboard input, screen
output, and disk I/O.
RM_OPT_SAVE_FIQ_REGISTERS=TRUE
This option determines whether the FIQ-mode registers are saved into the registers block when RealMonitor stops.
RM_OPT_READBYTES=TRUE
RM_OPT_WRITEBYTES=TRUE
RM_OPT_READHALFWORDS=TRUE
RM_OPT_WRITEHALFWORDS=TRUE
RM_OPT_READWORDS=TRUE
RM_OPT_WRITEWORDS=TRUE
Enables/Disables support for 8/16/32 bit read/write.
RM_OPT_EXECUTECODE=FALSE
Enables/Disables support for executing code from "execute code" buffer. The code must be downloaded first.
RM_OPT_GETPC=TRUE
This option enables or disables support for the RealMonitor GetPC packet. Useful in code profiling when real monitor is used in
interrupt mode.
RM_EXECUTECODE_SIZE=NA
To Next Page
Loading...