List of figures
3827_en_B PHOENIX CONTACT 133/138
Section 5
Figure 5-1: I/O data mode .....................................................................................69
Figure 5-2: Serial data mode .................................................................................69
Figure 5-3: PLC/Modbus RTU mode .....................................................................70
Figure 5-4: PLC/Modbus RTU dual mode .............................................................70
Figure 5-5: Configuration via CONFSTICK ...........................................................72
Figure 5-6: PSI-CONF software: Network Settings ...............................................75
Figure 5-7: PSI-CONF software: Wizard, Step 3 ...................................................76
Figure 5-8: PSI-CONF software: Setting the data transmission speed ..................76
Figure 5-9: PSI-CONF software: Individual Settings, Overview .............................77
Figure 5-10: PSI-CONF software: Individual Settings, Serial Port ...........................78
Figure 5-11: PSI-CONF software: Individual Settings, Allowed Parents ..................78
Figure 5-12: Assignment of digital inputs and digital outputs ..................................79
Figure 5-13: RAD-DAIO6-IFS assignment: analog/digital inputs and outputs .........79
Figure 5-14: Input module and output module with the same address ....................81
Figure 5-15: Thumbwheel addressing of the RAD-900-DAIO6 in point-to-point mode
83
Section 6
Figure 6-1: Serial data mode .................................................................................85
Figure 6-2: PSI-CONF software: Wizard, Step 3 ...................................................86
Figure 6-3: PSI-CONF software: Wizard, Step 4 ...................................................86
Figure 6-4: Frame-based data transmission: T
IdleMin
parameter ...........................87
Figure 6-5: Frame-based data transmission: T
FrameEnd
parameter .......................87
Figure 6-6: PSI-CONF software: Individual Settings .............................................88
Section 7
Figure 7-1: PLC/Modbus RTU mode .....................................................................89
Figure 7-2: PSI-CONF software: Wizard, Step 3 ...................................................90
Figure 7-3: PSI-CONF software: Individual Settings, Network Settings ................91
Section 8
Figure 8-1: PLC/Modbus RTU dual mode .............................................................93
Figure 8-2: PSI-CONF software: Wizard, Step 3 ...................................................94
Figure 8-3: PSI-CONF software: Individual Settings, Network Settings ................95
To Next Page
Loading...
