Pilz PNOZ s30 - Chip Card

Function description
Operating Manual PNOZ s30
1001715-EN-19
| 38
} Switch functions
– Standstill (F1)
Standstill frequency configurable in Hz
Default: 100 Hz
– Speed (F2)
Max. frequency (v max) configurable in Hz
Default: 5 kHz
– Direction (F3)
Left direction
Tolerance for wrong direction = 10 pulses
– Direction (F4)
Right direction
Tolerance for wrong direction = 10 pulses
} Parameter set/select input
P0, select inputs are ignored ("None" mode")
} Hysteresis
Standstill and speed, 2 % each
} Output assignment
– Standstill (F1): Relay output Rel. 1 and semiconductor output Out 1
– Speed (F2): Relay output Rel. 2 and semiconductor output Out 2
– Left direction (F1-F4): External output Ext. 1 and semiconductor output Out 3
– Right direction (F1-F4): External output Ext. 2 and semiconductor output Out 4
} Start mode
– All outputs: Automatic start
} Switch delay
None
} Max. encoder frequency
1 MHz
For details of how to configure the basic configurations, see the chapter entitled Commis-
sioning/Display Menu - Configuration
5.4.5 Chip card
The set parameters, the name of the configuration, the check sum and the passwords are
stored on the chip card. The error list can also be saved to the chip card. (See chapter "Use
chip card").