Display menu - Configuration
Operating Manual PNOZ s30
1001715-EN-19
| 65
Solution
Check all the parameters to make sure that the configuration is functionally identical and
make a note of the new CRC.
Then insert a new chip card and save the configuration on the chip card (see Write data to
chip card [ 60]).
If you no longer need the chip card data from the older version, then this can also be used.
8.6 Save configuration with Software SmartCardCommander
You have the option to save a PNOZ s30 configuration from the chip card to your computer.
The configuration can be saved on the computer and then downloaded to other chip cards.
To do this you will need the chip card reader PNOZ Chip Card Reader with the corres-
ponding SmartCardCommander software. Both are available from Pilz as accessories, in-
dividually or as part of a set (see Accessories [ 129]).
Save PNOZ s30 configuration on the computer
1. Make a note of the configuration's CRC in the PNOZ s30. It is shown on the display in
the Information/ Configuration CRC menu. This will be needed later to check whether
the correct configuration is saved on the device.
2. Remove the chip card from the PNOZ s30 and insert it into the holder for the chip card
reader.
3. Start the SmartCardCommander software.
4. Insert the holder containing the chip card into the chip card reader.
5. The Memory Card directory is displayed in a list under Hardware on the software inter-
face of the SmartCardCommander .
6. To read the data on the chip card, click on the Memory Card directory and then select
Read Data from Card.
To Next Page
Loading...
Need help?
General
