Display menu - Configuration
Operating Manual PNOZ s30
1001715-EN-19
| 64
1. The changed configuration exists
only in the device memory. The chip
card is locked for write access and all
parameter changes are made only in
the internal device memory. The cur-
rent configuration can be stored on
the chip card by inserting a new chip
card.
Current menu Upgrade SIM:
New CRC: 12345 (0…
65535)
No?
Insert rewritable SIM Card!
Do not allow the new configuration to be written to the chip card
If a chip card from a PNOZ s30 with an older device version was loaded and afterwards a
new chip card was inserted, it may also be necessary to update the configuration. See Du-
plicate chip card [ 62].
8.5.7 Special cases and problem solving
Outputs do not switch on correctly, although the same configuration works in
another device
Prerequisite:
} Chip card from a PNOZ s30 <v3.0
} Device PNOZ s30 v3.0
Error
When loading the stated chip card into the device, under certain conditions the "Synchron-
ous start" function can be activated unintentionally. In device versions <v3.0, this function is
not available.
Solution
Deactivate the "Synchronous start" option on all outputs (see Synchronous start [ 25]).
When a chip card is loaded, once the load process has been confirmed, the same
question is asked again in a continuous loop
Prerequisite:
} Chip card from a PNOZ s30 <v3.0
} Device PNOZ s30 v3.0
Error
The contents of the chip card were already loaded into the device memory after the initial
confirmation (see Read data from chip card [ 61]), but the CRC does not match the ori-
ginal CRC.
To Next Page
Loading...
Need help?
General
