Display menu - Configuration
Operating Manual PNOZ s30
1001715-EN-19
| 62
8.5.4 Transfer device parameters
You can transfer device parameters from one device to another using the chip card.
NOTICE
Please note:
If you transfer the device parameters from one device to a device with an
older device version, then it cannot be guaranteed that the safety functions
on the older device will behave in the same way. If device parameters are
used that do not exist in that device version, then these parameters will not
be recognised and, accordingly, this behaviour will be missing.
From devices with Version 3.1, the transfer of device parameters to older
devices is prevented.
To transfer the device parameters, proceed as follows:
Make a note of the configuration's CRC in the PNOZ s30. It is shown on the display in the
Information/ Configuration CRC menu. This will be needed later, to check whether the
correct configuration is saved on the device.
1. Remove the chip card containing the data from device 1.
2. Insert the chip card into device 2.
3. Confirm the message Load SIM Yes?.
4. The data is downloaded.
5. To ensure that the configuration has been transferred correctly, check that the CRC for
the configuration in the PNOZ s30 matches the configuration CRC you noted down.
8.5.5 Duplicate chip card
You can also create copies of a chip card and its data.
Follow the instructions below:
} Remove chip card containing the device data.
} Insert a new chip card into the device.
} Confirm the message Write configuration to SIM Yes?.
} The new chip card is written.
With configurations from devices with an older device version, it may not be possible to cre-
ate a compatible copy of the original chip card.
The message appears: Config.Upgrade?
To Next Page
Loading...
Need help?
General
