Pilz PNOZ s30 User Manual

Create configuration in PNOZsigma Configurator
Operating Manual PNOZ s30
1001715-EN-19
| 88
Download project via cable from the PNOZsigma Configurator to the PNOZs30
1. Connect the PNOZ s30 with a free USB interface of your computer. To do this, use the
cable PNOZ s30 USB-configuration-cable (order no.: 750 040), which is available at
Pilz as an accessory [ 129].
2. In the PNOZsigma Configurator, click on the project to be downloaded in the Project
Overview and click on the button in the project to download the configuration to
the PNOZ s30.
Please note: Existing data on the PNOZ s30 is overwritten.
3. To ensure that the configuration has been transferred correctly, check that the Config-
uration CRC in the PNOZs30 matches the CRC that is shown in the title bar in the
PNOZsigma Configurator.
Note: Download mode can be cancelled using the rotary knob.
1. 2.
DOWNLOAD MODE Cancel
DOWNLOAD
MODE?
9.2 Transfer project from PNOZs30 to the PNOZsigma
Configurator
It is possible to download a configuration from PNOZs30 to the PNOZsigma Configurator
and to create a new project there.
Transfer project via chip card from PNOZs30 to the PNOZsigma Configurator
1. Ensure that the required configuration is saved to the chip card (see chapter Write data
to chip card [ 60]).
2. Remove the chip card from the PNOZ s30 and insert it into the holder for the chip card
reader.
3. In the PNOZsigma Configurator, click on the start page on the button to download
the configuration to the chip card.
When the download is complete, the configuration is created in PNOZsigma Configurator
as a project.

Pilz PNOZ s30 Specifications

General

Brand	Pilz
Model	PNOZ s30
Category	Relays
Language	English