EasyManuals Logo

Planet IGS-20040MT User Manual

Planet IGS-20040MT
381 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
User’s Manual of IGS-20040MT
2.1.5 Wiring the Fault Alarm Contact
The fault alarm contacts are in the middle (3 & 4) of the terminal block connector as the picture shows below. Inserting the wires,
the Industrial Managed Switch will detect the fault status of the power failure, or port link failure (available for managed model).
The following illustration shows an application example for wiring the fault alarm contacts
Insert the wires into the fault alarm contacts
1. The wire gauge for the terminal block should be in the range of 12 ~ 24 AWG.
2. When performing any of the procedures like inserting the wires or tighten the wire-clamp screws, make
sure the power is OFF to prevent from getting an electric shock.
27

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Planet IGS-20040MT and is the answer not in the manual?

Planet IGS-20040MT Specifications

General IconGeneral
Switch typeManaged
Switch layerL2+
Traffic classificationYes
Console portRJ-45
Fiber optic connectorMiniGBIC
SFP module slots quantity4
Installed SFP modules quantity0
Basic switching RJ-45 Ethernet ports typeGigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity16
10G supportNo
Number of VLANs4095
Networking standardsIEEE 1588v2, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1ab, IEEE 802.1ad, IEEE 802.1ag, IEEE 802.1p, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3ah, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Virtual LAN featuresStacked VLAN, Private VLAN, Tagged VLAN, Protocol-based VLAN
Copper ethernet cabling technology10BASE-T, 100BASE-TX, 1000BASE-T
Stackable-
CertificationFCC, CE
Product colorBlue, White
Housing materialAluminum
International Protection (IP) codeIP30
Fiber ethernet cabling technology100BASE-FX, 1000BASE‑BX, 1000BASE‑LX, 1000BASE‑SX
Throughput29.7 Mpps
Jumbo frames9216
MAC address table8000 entries
Number of IP interfaces8
Power consumption (max)17 W
Power consumption (typical)8 W
Heat dissipation27 BTU/h
Storage temperature (T-T)-40 - 85 °C
Operating temperature (T-T)-40 - 75 °C
Operating relative humidity (H-H)5 - 95 %
Supported network protocolsIPv4 / IPv6
AuthenticationMAC-based authentication, Port-based authentication
Security algorithms802.1x RADIUS, SSH, SSL/TLS
Number of multicast groups filtered255
Harmonized System (HS) code85176990
Weight and Dimensions IconWeight and Dimensions
Depth107.3 mm
Width76.8 mm
Height152 mm
Weight1043 g

Related product manuals