User’s Manual of IGS-20040MT
60
By default setting, most groups privilege level 5 has the read-only access and privilege level 10 has the
read-write access. And the system maintenance (software upload, factory defaults and etc.) need user
privilege level 15.
Generally, the privilege level 15 can be used for an administrator account, privilege level 10 for a
standard user account and privilege level 5 for a guest account.
Once the new user is added, the new user entry is shown on the Users Configuration Page.
Fig
ure 4-2-6: User Configuration Page Screenshot
If you forget the new password after changing the default password, please press the “Reset”
button on the front panel of the Industrial Managed Switch for over 10 seconds and then release
it. The current setting including VLAN will be lost and the Industrial Managed Switch will restore
to the default mode.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
