User’s Manual of IGSW-24040T
1. It recommends using PLANET SFPs on the Managed Switch. If you insert a SFP transceiver that
is not supported, the Managed Switch will not recognize it.
2. MGB series SFP modules are guaranteed working under -10 ~ 50℃ environmet, but MGB-TSX /
MGB-TLX / MBG-T30 / MGB-T70 supports to -40 ~ 75℃.
3. MFB series SFP modules are guaranteed working under -10 ~ 50℃ environmet, but MFB-TFX /
MFB-TF20 supports to -40 ~ 75℃.
Before connect the other Managed Switches, workstation or Media Converter.
1. Make sure both side of the SFP transceiver are with the same media type, for example: 1000Base-SX to 1000Base-SX,
1000Bas-LX to 1000Base-LX.
2. Check the fiber-optic cable type match the SFP transceiver model.
To connect to 1000Base-SX SFP transceiver, use the Multi-mode fiber cable- with one side must be male duplex LC
connector type.
To connect to 1000Base-LX SFP transceiver, use the Single-mode fiber cable-with one side must be male duplex LC
connector type.
Connect the fiber cable
1. Attach the duplex LC connector on the network cable into the SFP transceiver.
2. Connect the other end of the cable to a device – switches with SFP installed, fiber NIC on a workstation or a Media
Converter..
3. Check the LNK/ACT LED of the SFP slot on the front of the Managed Switch. Ensure that the SFP transceiver is operating
correctly.
4. Check the Link mode of the SFP port if the link failed. Co works with some fiber-NICs or Media Converters, set the Link
mode to “1000 Force” is needed.
Remove the transceiver module
1. Make sure there is no network activity by consult or check with the network administrator. Or through the management
interface of the switch/converter (if available) to disable the port in advance.
2. Remove the Fiber Optic Cable gently.
3. Turn the handle of the MGB module to horizontal.
4. Pull out the module gently through the handle.
34
To Next Page
Loading...
Need help?
General