7.14
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
6. Using an appropriate bearing/bushing installation
sleeve, drive the support bearing assembly onto the
propshaft until it seats against the shoulder on the
shaft.
NOTE: Take care while installing the support
bearing assembly. Be sure to only drive on the
inner race of the bearing. Driving on the bearing
or support in any other location will damage the
bearing or support assembly.
7. Wipe the bearing and shaft clean of any excess
retaining compound.
NOTE: Use care to not allow any of the Loctite
®
compound to get in the bearing.
8. Install the rear prop shaft into the vehicle (see “Rear
Prop Shaft Installation” procedure).
FINAL DRIVE
To Next Page
Loading...
