To Next Page

To Previous Page

7.13

9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual

NOTE: Paint marks are applied to the front and

rear propshafts to aid shaft alignment. Reference

these marks during installation if still visible.

5. Torque the support bearing fasteners to specification.

Support Bearing Fasteners:

35 ft-lb (47 Nm)

Support Bearing Replacement

1. Remove the rear prop shaft from the vehicle (see

“Rear Propshaft Removal” procedure).

2. Using a rubber mallet, remove the rubber isolated

bearing support from the shaft to expose the bearing.

3. Using a commercially available 2-jaw puller, remove

the bearing from the end of the propshaft.

4. Clean the bearing mounting surface on the shaft and

apply Loctite

603

™

retaining compound to the

clean surface.

5. Install the new support bearing assembly onto the

end of the prop shaft.

NOTE: Do not attempt to separate the bearing

from the rubber isolated support assembly upon

installation.

FINAL DRIVE

Polaris 2014 RZR XP 1000 Service Manual

Questions and Answers: