8.96
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
2. Obtain a new rebound adjuster screw O-ring and coat
it with shock oil. Install the O-ring onto the adjuster
screw groove. Install the detent ball spring and ball.
Screw the assembly back into the eyelet.
3. Secure the shock rod using the 5/8″ shock rod
holding tool, PN: 2872429, in a bench vise. Apply a
very small amount of Loctite 263 to the rod threads.
Screw the eyelet back onto the shock rod, but do not
bottom-out the eyelet.
NOTICE
If the eyelet
w
is bottomed-out on the shock rod
q
, the
rebound adjuster screw will bind. Likewise, the
application of too much Loctite may prevent the
rebound rod and/or adjuster screw from working. The
brass ball
e
and set screw
r
are designed to crush
against the rod threads and prevent the rod from
loosening.
STEERING / SUSPENSIONS
To Next Page
Loading...
