To Next Page

To Previous Page

Slide Scanner Repair Manual Diagnostics and Troubleshooting

115

Table 5-5. Scanner Tester Panel

Item Box Description

Scanner SN Used to enter the serial number (ID) of the slide scanner to be

tested.

Station Name If applicable, used to enter the test station name.

CCD Configuration Allows the user to update or leave unchanged, the CCD

configuration. This selection is used when the CCD is

replaced with a newer generation unit.

CCD Config Data After a test cycle is completed, the scanner test panel reports

the type of CCD used in the slide scanner. Type 0 or 1.

GMT Test Sequence Lists the image quality tests that are sequenced when the

Geometric (GMT) test target is being used.

1 = Do test -Allows the user to select all or a particular

image quality test. The tester default is all

tests selected.

One (1) indicates that the particular image

quality test is selected.

Zero (0) indicates that the particular image

quality test is not selected.

P/F (Pass/Fail)-Indicates whether or not a selected image

quality test passed (P) or failed (F).

CT Test Sequence Lists the image quality tests that are sequenced when the Color

(CT) test target is being used.