16
Slide Scanner Repair Manual Scanner Overview
Table 1-2. Slide Scanner Features (Cont'd)
Feature Description
SCSI Receptacles SS35/SS35 ES: (Top and Bottom)
Two (2) 50-pin standard SCSI receptacles.
SS35 PLUS:
One (1) 50-pin standard SCSI receptacle.
One (1) 25-pin standard SCSI receptacle.
SCSI Cable This cable (25-pin and 50-pin connector ends) connects
the slide scanner to the host computer.
Note: The 50-pin end of the SCSI cable connects to the
top SCSI receptacle. The 25-pin end of the SCSI
cable connects to the 25-pin SCSI port at the
rear of the host computer (Adaptec AT-to-SCSI
Host Adapter port for Windows version).
SCSI Terminator SS35/SS35 ES:
SCSI terminator connects to the bottom receptacle.
SS35 PLUS:
SCSI terminator built in. To activate SCSI terminator,
set SCSI terminator switch to its ON position.
Notes: • To function properly, a SCSI chain must be
terminated at each end.
• The Adaptec AT-to-SCSI Host Adapter for
Windows version is internally terminated, which
means that it is the first one of the required
terminators.
• If the slide scanner is the only SCSI device to
be connected to the host computer, connect the
SCSI terminator to the bottom SCSI receptacle.
For SS35 PLUS turn on the terminator switch.
To Next Page
Loading...