1. Press Go to start a manual workout and set the RESISTANCE to level 5.
2. Pedal the machine while changing the INCLINE control from minimum to max-
imum range while verifying the machine operation:
l
Make sure that the console INCLINE motion control operation is smooth
and working correctly.
l
Verify that the console INCLINE level indicators are showing correct
information.
l
Verify that the ramp can reach the maximum and minimum incline levels.
l
Verify that the lift motor operation is smooth while changing the INCLINE
from minimum to maximum levels.
l
Concentrate on the feel of the stairarms and the rolling of the wheels on
the ramp. Be on the alert for unusual noises, bumps or movements.
3. Press RESET to end the workout.
STOP Button Test
Verifies the emergency STOP button operation.
1. Start a manual workout and set the RESISTANCE to 10.
2. Press the emergency STOP button and verify that the resistance resets to 0.
Heart Rate Monitor Test
Verify the Handheld Handlebar Heart Rate (HHHR
1
) function.
1. Access the Hardware Validation Test (51765761) and do the Heart Rate Test.
Return to service
1. Verify that there are no new error codes listed in the Error Log.
2. Switch the power OFF.
3. Make sure that the machine is setting level and stable.
4. Make sure that any external power cords or interface cables are properly
routed, connected, and safe from being damaged.
5. On successful completion of all verification tests, return to service.
1
Handheld Handlebar Heart Rate
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 24
3 Operation Verification
R20 Operation Verification Test
To Next Page
Loading...
Need help?
General
