DIAGNOSTIC TEST TEST DESCRIPTION
l
Nominal value: 242 ±5 @ 15% incline
Information Display (65)
menu: Settings > Information.
Service Access Code: 65 (see "" on page37)
The Information Display provides the equipment usage, hardware, software, error code,
and maintenance information:
INFORMATION DISPLAY DESCRIPTION
Softkeys
Home softkey Select Home to exit and return to the Home page.
Error Log softkey Select Error Log to open the Error Log table, see ."Error
Log Display" on page216
Information Parameters
ODOMETER The total number of accumulated miles (or kilometers) on
the unit.
This value is stored in the upper PCA
1
in the console so if
the PCA is replaced the accumulated miles would start
again from "0".
USAGE The total machine usage hours (hours : min).
This value is stored in the upper PCA in the console so if
that PCA is replaced the hours of use would start again
from "0".
SW Release P'N The operating system software part number.
Hardware Version Hardware version.
Console S/N Console serial number.
LPCA
2
VersionSW The LPCA software version.
uPA BOOT SW The console upper boot software version information.
1
Printed circuit assembly, generally referred to as either an upper PCA or lower PCA.
2
Lower Printed Circuit Assembly board; also refered to as the Lower PCA or simply as the
lower board. On treadmills, it is the console to base function interface and the motor con-
troller unit (MCU). On self-powered units, it is the lower PCA console to base function inter-
face.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 41
4 Standard Service Menus
Standard Service Menus
To Next Page
Loading...
Need help?
General
