DIAGNOSTIC TEST TEST DESCRIPTION
Beeper Test Beeper sounds once every second.
Keypad Test Press all hard keys and verify change to the pattern. The test will
exit when all keys have been pressed. Pressing down Workouts
for 5 seconds also exits the test.
LCD
1
Test Test will light up all segments and sections of the display.
Heart Rate Test Heart rate is acquired and displayed.
Belt Speed Test Menu: Machine Test > Belt Speed Test
Range: 0.5 mph to 12.0 mph in 0.1 increments.
l
Press Go to start the Belt Speed Test (IMPORTANT the
running belt will start movint).
l
Use the SPEED control to very speed.
Incline Test Use controls to raise/lower incline to verify the following incline
angle A/D values:
l
Nominal value: 13 ±5 @ -2% incline
l
Nominal value: 37 ±5 @0% incline
l
Nominal value: 242 ±5 @ 15% incline
Information Display (65)
Service Access Code: 65 (see "R20 How To Access Standard Service menus" on page39)
The Information Display provides the equipment usage information, software pn/version
information, and Error Log access.
INFORMATION DISPLAY DESCRIPTION
ODOMETER The total number of accumulated miles (or kilometers) on
the unit.
This value is stored in the upper PCA in the console so if
the PCA is replaced the accumulated miles would start
again from "0".
HOUR METER The total number of hours that the unit took to accumulate
unit miles.
This value is stored in the upper PCA in the console so if
that PCA is replaced the hours of use would start again
1
liquid crystal display.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 43
4 Standard Service Menus
Standard Service Menus
To Next Page
Loading...
Need help?
General
