List Of Messages
43
33 PLATEN OPEN
TIMEOUT
In the CT emulation with a
coax interface, the forms
thickness lever has been
open for at least one minute.
1. Load paper. Close the forms
thickness lever. Press CLEAR.
2. Run a print test. If a platen open
or close platen message
appears, power off the printer.
Remove the paper path or
pedestal top cover. Disconnect
connector P107 from the
controller board. Check continuity
of the platen interlock switch
cable from P107 to the switch.
Replace the platen interlock
switch assembly if it fails
continuity test.
3. Run a print test. If a platen open
or close platen message
appears, replace the controller
board. Record the message and
return it with defective board.
Table 2. Message List
Message Explanation Solution
To Next Page
Loading...
