PRISMJET 54 Gen2 - Confirm Print Menu; Micro Adj.change Menu

PrismJET 54 Gen2 OPERATION MANUAL Panel setup menu
5.1 Setup menu 161
(4) Confirm Print menu
Performs Confirm Print.
(5) Micro Print menu
Performs Micro Adjustment Print.
(6) Micro Adj.Change menu
Sets up Micro Adjustment Change.
Setup item Setting Description
FeedLength 100mm to <250mm> to
500mm
Changes the length (feed length) of the media feed direction
for Confirm Print.
• [Enter] key:
Determines the setting.
“Printing” is displayed on the operation panel and Initial
Print starts.
After printing, the printer enters Normal.
—
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1.1.1.4 Dist.Adj menu
Setup item Setting Description
Micro Print -5.00% to <0.00%> to 5.00%
(After printing)
• Prints a micro adjustment pattern based on the currently set
micro adjustment value with each of the following values
applied to it.
±0.10%、±0.20%、±0.50%、±0.80%、±1.20%
• After printing, enter a micro adjustment value in the
following range:
-5.00% ～ <0.00%> ～ 5.00%
—
• [Cancel] key: shifts to the previous menu.
Stops printing and returns to the previous menu if printing
is in progress.
5.1 Setup menu
Setup item Setting Description
Micro Adj.Change -5.00% to <0.00> to 5.00% Sets up Micro Adjustment Change.
—
• [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu