PRISMJET 54 Gen2 - Pre-Heater Menu

To Next Page

To Previous Page

Panel setup menu PrismJET 54 Gen2 OPERATION MANUAL

162 5.1 Setup menu

5.1.1.1.5 Pre-heater menu

Sets the temperature of the pre-heater.

Set to curb a rapid temperature change at the printing portion by pre-heating the media before printing.

NOTE

• The set temperature of the pre-heater differs depending on the media.

Setup item Setting Description

Pre heater Off / <30 °C> to 50 °C Sets the temperature of the pre-heater.

1.Roll media

2.Pre heater

3.Print head

—

• [Enter] key: saves the setting and shifts to the previous

menu.

• [Cancel] key: cancels the setting and shifts to the previous

menu.

5.1.1.1 User Type menu