Before using PrismJET 54 Gen2 OPERATION MANUAL
74 3.6 Adjust Print
3.6 Adjust Print
It is used for optimizing the quality of image prints.
Adjustment methods for this printer are as follows.
• When newly setting or changing the user type setting after adjusting Standard adjust print, make
sure to adjust print.
• If print defects (like banding or grainy look) still appear on the print, try an auto calibration again,
or go to "Standard" or "Custom" to perform calibration.
3.6.3 Standard Adjust Print
3.6.4 Custom Adjustment Pattern
• When the print mode is changed after Standard adjust print, perform Standard adjust print again.
• Since all print modes are adjusted at once after performing Custom adjust print, adjust print is not
required even after changing the print mode.
• When specifying a print mode for RIP software, etc, that is different from the mode set in the
usertype setting, perform Custom head adjustment and check all patterns (A to F), and then adjust
any patterns that are misaligned beforehand.
• "Adjust Print" requires at least 21.6” (550 mm) printable width. Before printing, make sure that
there is sufficient width on the media.
If printable width is less than 21.6” (550 mm), your printer will not perform printing. Printable
width on the media can be adjusted by changing CR origin and side margin (left and right side
margin) settings.
5.1.3 Side Margin menu, 5.1.5 Media Width menu, 5.1.8 Origin menu
Adjustment
method
Description Reference
Auto Perform an automatic calibration that the printer
automatically prints and scans a pattern with the embedded
color sensor to correct dot placement.
3.6.2 Auto Adjust Print
Standard Adjusts only the print mode used by the current user
definition. When you have adjusted the print mode using
Standard, make the resolution, pass count, and print direction
of the print mode on the RIP side equal to those of the user-
defined print mode
3.6.3 Standard Adjust Print
Custom Allows you to adjust also a print mode other than the print
mode used by the current user definition. This method
optimizes print quality even if the print mode on the RIP side
is different from the user-defined mode.
3.6.4 Custom Adjustment
Pattern
To Next Page
Loading...