PRISMJET 54 Gen2 - Loading Media

PrismJET 54 Gen2 OPERATION MANUAL Before using
3.4 Loading media 55
3.4 Loading media
This section explains how to load and set media, and settings for each media type.
NOTE
Refer to the following for details about handling media.
4.2 Media
3.4.1 Loading roll media
This section describes the procedure to load the roll media.
To load the roll media, use the scroller included with the printer.
NOTE
The following roll media can be loaded on the scroller included with the printer.
• Media tube with a diameter of three inches: Less than 6 inches (150 mm) in outer diameter, less
than 42lbs (19 kg) in weight.
• Media tube with a diameter of two inches: Less than 6 inches (150 mm) in outer diameter, less
than 42lbs (19 kg) in weight.
Follow the procedure below to load the roll media.
CAUTION
• When loading the roll media, place it on a flat surface such as a desk.
If the roll media is loaded with the scroller up, the scroller may be damaged.