PRISMJET 54 Gen2 - Media Initial Menu

PrismJET 54 Gen2 OPERATION MANUAL Panel setup menu
5.1 Setup menu 171
5.1.4 Media Initial menu
Sets whether to detect the media width and edge while initializing the media.
NOTE
• Set the media width that is set in the Media Width menu when setting “Off” in the Media detection
menu.
5.1.5 Media Width menu
• When the Media detection menu is set to “Off”, the media cannot be cut automatically.
Setup item Setting Description
Init. Off The media is not detected.
Top & Width Detect the media width and edge while initializing the media.
<Width> Detect the media width while initializing the media.
—
• [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu