PRISMJET 54 Gen2 - Page 39

PrismJET 54 Gen2 OPERATION MANUAL Before using
3.3 Installing ink cartridges 49
NOTE
• If the printer performs the nozzle check printing immediately after initial ink charge is complete,
the following results may occur.
• Printed lines become blurred.
• The data is partially not printed.
In such cases, follow “
6.2.3 Head cleaning” and perform “Little Charge”. Then, check the
printing result.
If there is no improvement in the print result even after performing “Little Charge”, leave the printer
unused for an hour or more. Then, perform “Little Charge” again and check the print result.
If there is still no improvement, contact SIGNWarehouse Product Support.