86
Trinity F90+ user manual
After planning the mission in QBase follow the steps below for the ight setup.
The steps 8.1 – 8.12 must be completed in the following order.
8.1 Step 1 – Ensure that the weather conditions are suitable for ying
It is possible to y the UAV under the following conditions:
1. Wind up to 9 m / s (17.5 kn) (See chapter 3.1.)
In addition to wind data provided by QBase or meteorological service check the
actual windspeed using the anemometer.
MODE SET
First time start-up of the anemometer
• Switch on the anemometer by pressing and holding MODE for 2 seconds.
• Set measuring method to MAX by pressing MODE for 3 seconds till m/s is blinking.
Press SET until MAX is shown blinking. Press MODE to conrm.
• To reset the MAX-value press MODE for 3 seconds till m/s is blinking.
Then press MODE to conrm.
For more details see the brief manual delivered with the anemometer.
2. Temperature -12 °C to 50 °C (10.4 °F to 122 °F)
Below 0 °C (32 °F): non icing conditions, battery must be heated to 25 °C (77 °F) for at least ve hours before the ight
and the ight time is limited to 60 minutes. Do not y in rain or snow.
08 FLIGHT SETUP – STEP BY STEP
To Next Page
Loading...