Preventive Maintenance
400-088-120-02 Page 4.4-93 Rev. Date: 10/2016
4.4.5 Pin Changing Procedure
1. Cycle the pinspotter to spot a full set of pins on the pin deck and to store a full
set in the bin pockets.
2. Push the Sweep Run button to sweep all of the pins into the pit.
3. Turn power to the pinspotter OFF.
4. Remove the old pins from the pit area, and replace with a new set.
5. Turn the pinspotter on and press the cycle button. This will place the second old
set of pins on the lane and start loading the bin with new pins.
6. When the new set of pins has been loaded into the bin, repeat steps 2, 3, and 4.
7. Press the cycle button to complete the pin changing procedure.
To Next Page
Loading...
Need help?
General