Section 3.
Pinspotter Mechanical Operation
400-088-120-02 Page 3-11 Rev. Date: 10/2016
3.2.8.2 Ball Detector Cable Connections
The two optical emitters/sensors are prewired to the two terminal strips, one
optical emitter/sensor and one terminal strip per lane (odd, even). The wire
codes for the optics are ‘Blue’ – Ground, ‘Brown’ - +12, and ‘Black’ – Signal.
The Ball Detect Cable (088-000-508) has a Molex 12 position connector that
plugs into the XLi Chassis and 6 wires (connectors) that will attach to the
terminal strips of the ball detector. Two wires are identified with ‘Brown’ heat
shrink tubing, two wires with ‘Blue’ heat shrink tubing, one wire with an ‘ODD’
label, and one with an ‘EVEN’ label.
Insert the ball detect cable thru the grommet.
MOUNT ON CENTERLINE
ACROSS LANES
To Next Page
Loading...