QubicaAMF XLi EDGE Series - Xli Steel Table Tool Kit; Motor Crank

Section 4.1.
Service Tools
400-088-120-02 Page 4.1-3 Rev. Date: 10/2016
4.1.1b XLi Steel Table Tool Kit
Figure 4.1-1b, XLi Steel Table Tool Kit - P/N 784-528-014
Table 4.1-1b, XLi Steel Table Tool Kit Parts List
ITEM
QTY
PART#
DESCRIPTION
1
1
792-505-005
Spring Puller
2
1
785-005-005
Grease Gun w/Extension
3
1
030-003-542
Clipper Belt Lacer
4
1
792-505-036
Spring Puller (short end)
5
1
793-511-045
Adjustable Spanner Wrench
6
2
792-501-001
Pit Conveyor Belt Removal Pins
7
1
792-502-002
Pit Conveyor Belt Tool Flag
8
2
070-006-519
Respot Gauge
9
3
090-005-525
Steel Table Locating Tool
10
1
784-003-000
Pit Conveyor Belt Installation Tool Handle
11
2
088-001-216
Multigage – Frame, Sweep, Distributor
12
1
088-001-217
Yoke Toe Gage
13
1
030-004-031
Pin Extracting Tool
14
1
088-000-207
Mini-Fit Pin Extractor
15
1
088-000-204
Pin Pusher (extracting tool)
16
1
088-001-635
Home and Encoder Tester
4.1.1c Motor Crank
The XLi EDGE Pinspotter’s table and sweep drive motors can be operated
manually to position the table or sweep for maintenance or adjustment. The
drive motors contain a brake that must be manually released before hand
cranking the motor, and will automatically re-engage when the brake lever,
located at the top of each motor, is released. A new motor crank tool (P/N
088-000-033) is also provided. The design of the tool prevents insertion of the
tool with drive power connected. Use only the motor crank tool provided with
the pinspotter for manual operation of the table and sweep drive motors.
Figure 4.1-1c