Contents
4.6.4 Cushion and Pit Troubleshooting .......................................................... 4.6-22
4.6.4.1 Ball idles at cushion ............................................................... 4.6-22
4.6.4.2 Ball idles at exit ..................................................................... 4.6-23
4.6.4.3 Ball failed to cycle machine ..................................................... 4.6-24
4.6.4.4 Machine cycles continuously or randomly ................................. 4.6-25
4.6.4.5 Back end motor trips on overload ............................................ 4.6-26
4.6.5 Chassis Troubleshooting....................................................................... 4.6-27
4.6.5.1 Table time delay too long or too short ...................................... 4.6-27
4.6.5.2 Sweep time delay too long or too short .................................... 4.6-28
4.6.5.3 Cannot turn machine on from MCU .......................................... 4.6-29
4.6.5.4 1
st
ball scores okay, second doesn’t score ................................. 4.6-30
4.6.5.5 1
st
ball doesn’t score, 2
nd
ball scores okay ................................. 4.6-31
4.6.6 Motor Troubleshooting ........................................................................ 4.6-32
4.6.6.1 Table motor runs continuously ................................................ 4.6-32
4.6.6.2 Sweep motor runs continuously .............................................. 4.6-33
4.6.6.3 Front end motor will not run ................................................... 4.6-34
4.6.7 Pin Deck Light Troubleshooting ............................................................ 4.6-36
4.6.7.1 Pin deck light will not turn on .................................................. 4.6-36
To Next Page
Loading...