QubicaAMF XLi EDGE Series - Page 184

Troubleshooting
400-088-120-02 Page 4.6-35 Rev. Date: 10/2016
Section 4.6
4.6.6.3 PROBLEM: Front end motor will not run. (Continued from
previous page.)
Figure 4.6-34
YES
YES
YES
Thermal overload
switch tripped?
(continued)
NO
NO
Machine power
cable defective?
Check with continuity
tester. If defective,
repair or replace cable.
Defective
chassis?
Replace chassis.
Power at the
motor plug?
Repair or replace
motor.
NO