XLi EDGE QubicaAMF Pinspotter
Section 3 Page 3-14 Rev. Date: 10/2016
3.2.8.5 Ball Detector Maintenance & Cleaning Recommendations
The system is designed to operate properly with a significant amount of dust
and dirt accumulation on the optics. Periodic cleaning of the reflector surfaces
and detector heads will help ensure proper operation.
NOTE: It is recommended that the units be covered during any lane
maintenance that generates large amounts of dust and dirt.
1. Use a clean, soft cloth to gently wipe the face of the reflectors on the
reflector units as well as the detector heads.
2. If gentle wiping does not remove the dirt, it may be due to grease or oil
accumulation. A mild soap (such as dishwashing liquid soap) and water
solution may be used. First wash and then gently wipe dry.
Do not use abrasive cleaners or strong solvents as they may
permanently damage the surfaces.
To Next Page
Loading...
Need help?
General