QubicaAMF XLi EDGE Series - Page 61

XLi EDGE Pinspotter
Section 4-2 4.2-2 Rev. Date: 10/2016
Figure 4.2-1
3. From the 7-10 line it should measure 6-1/2  1/8 inches to the front edge of the kickback
plates (see B in Figure 4.2-2). This distance can be adjusted by adding or removing washers
from the junction of the front-end and back-end units.
Figure 4.2-2
F
R
A
M
E
Use a straight piece of lumber or
other straightedge to extend deck
elevation for measurement.
PIN DECK
18-7/8”